Added by on 2019-01-21

Watch the Video “How to Make a Nano Aquarium” – https://youtu.be/EgvocALYXc0 Standing Seam Metal Roofing. How to Install Standing Seam Metal Roofing. ♦DIY CAM♦ These instructions specifically focus on metal panel installation. To learn more about eave trim and cleat installation, view our other how-to videos. The panel used in this example is a 16-inch coverage panel with a nail flange. We will show you how to install these metal panels with both exposed fasteners and hidden fasteners. Exposed Fastener Installation Step 1: Start Square When you’re installing a metal roofing panel, the first thing that you want to do is make sure you’re starting square. This means that your vertical lines are all running square to your eave. It’s important to start square because if the first panel is tilted a little bit, all the panels that come after are going to be tilted as well. When you’re starting the roof, you want to square off the edge and adjust your panel if necessary. For example, if this particular roof was off a little bit, even by just half an inch, I would tilt our panel a little bit so that we ran square, starting with the first panel. Step 2: Cut Panel to Length & Add Eave Trim The panel we are using is too long. When you’re doing an exposed fastener eave installation, you want to overhang the eave by one and a half or two inches at most. Put your tape up against the end wall and measure down to the edge of your eave trim. For this example, it’s exactly 24 inches, and I’m going to add an inch and a half to that measurement and cut my panel to length. To do so, flip the panel over and make marks on the reverse side. […]

Leave a Reply

Your email address will not be published. Required fields are marked *

*

 

7 Comments

  • Tom Hackett 3 months ago

    Awful lot of screw holes in that roof you didn't need to do that there's other ways

  • Kirby Spencer 3 months ago

    You suggest all of these cuts but never once say how to calculate or perform them.

  • mike suart 3 months ago

    What happens to the cut edges as this is bare metal, does it not rust?

  • Whitecraig 126 3 months ago

    Can you buy the panels and flashings (red panel style) in the UK?

  • randy beard 3 months ago

    I Hope that Everyone Passed Geometry, Replicating this video on a Real Roof might be Difficult…

  • Brick Wall 3 months ago

    Best video I ever seen on metal roof installs! nice job.

  • Ernesto Lopez Mendez 3 months ago

    good