Added by on 2016-03-22 How to Make a Hydroponic DWC Bubbler System, The Fittings, Products and Tools used for this thread are as follows: 20L Bucket and lid (Black) 140mm Net pot 4mm Airline tubing Elite 800 airpump 15mm Green food grade tubing 15mm Grommet 4″ Round airstone Drill hole cutting/enlarging bit 140mm Hole cutter 4mm drill bit Video Rating: / 5 Related PostsBubbler Hydroponic Growing System – How To Set UpPi Wall Vertical Hydroponic Grow System Living WallsHow to make a Top Drip Bucket Hydroponic SystemSuperPonics SuperFlow Hydroponic System By SuperClosetFlo n Gro Flood and Drain System explained – Grow Show Hydroponic SuppliesHow-to build a 5 gallon hydroponic DWC system with trellis for cucumbers

Leave a Reply

Your email address will not be published. Required fields are marked *




  • Jay Thompson 1 year ago

    how does the water flow from the reservoir into other buckets also how do u fully change the solution or are u constantly addingto the same reservoir? is this not bad for salt or other build ups if used on a bigger scale thanks

  • NZ BUDZ 1 year ago

    the 15mm elbow is 2 mm's too big for the 13 mm hole, and then to put a grommet in the hole will be another 2 mm's smaller still for the elbow?…

  • Ron Conrad 1 year ago

    Well the first time ever at being first for anything, lol. You got some nice looking plants, hope to see more.

  • Ron Conrad 1 year ago

    Nice Job. Am I the only one that left a comment?